B.TechSemester 12024-25Fundamentals Of Electrical EngineeringBEE101

Fundamentals Of Electrical Engineering (BEE101) - AKTU Question Paper 2024-25

B.Tech · Semester 1 · Free PDF Download

This is the official AKTU Fundamentals Of Electrical Engineering Previous Year Question Paper for B.Tech Semester 1, academic session 2024-25. Published by Dr. A.P.J. Abdul Kalam Technical University (AKTU/UPTU), Lucknow. Free PDF download — no login required.

Course:B.Tech
Semester:Semester 1
Session:2024-25
University:AKTU / UPTU

Rate this paper

Questions Asked in 2024-25

Fundamentals Of Electrical Engineering (BEE101) — complete question paper · 70 marks · 3 Hours

Section AAttempt all questions in brief. 2 x 07 = 14
  • a
    Define bilateral and unilateral element
  • b
    Define the RMS value and write the formula
  • c
    A resistance of 15Ω, choke coil of 0.05 H and the capacitor of 0.03 F are connected in series. Find the imp edance of the circuit if frequ ency is 50
  • d
    Draw the phasor diagram of pract ical transformer at no load condition
  • e
    Write the condition for maximum efficiency of transformer
  • f
    Define the commutator in DC machine
  • g
    What is Switch fuse unit(SFU)?
Section BAttempt any three of the following: 7 x 3 = 21
  • a
    Find the current I 1 and I2 using the Mesh analysis
  • b
    What is resonance curve and prove the bandwidth of resonant frequency
  • c
    Derive series resonance frequency in R-L-C circuit. A series R-L-C circuit has R=20 , L=0.1H and C=0.09F. Determine (i) Resonant frequency (ii) Q factor of the circuit at resonance. (iii) Bandwidth
  • d
    A three phase 50Hz ,2 pole induction motor has a full speed of 2860 rpm. What is the (i) synchronous speed (ii)slip of the induction motorand (iii) rotor emf frequency?
  • e
    Explain construction of underground cable? Explain each laye r of cable with neat diagram. Why used of bedding in cable?
Section CAttempt any one part of the following: 07 x 1 = 07
  • a
    Find the voltage V 1 and V2 using nodal analysis
  • b
    Find the value of the currents I 1, I2 and I3 flowing clockwise in the first, second and third mesh respectively
  • a
    Explain the phenomenon of parallel resonance circuit. Also d erive the formula for resonant frequency of the circuit with a pure capac itor in parallel with a coil having resistance and inductanceas shown figure
  • b
    A series RLC circuit containing a resistance of 12Ω, an indu ctance of 0.15H and a capacitor of 100uF are connected in series across a 100V, 50Hz supply. Calculate the total circuit impedance, the circuit s current, power factor and draw the voltage phasor diagram
  • a
    The primary and secondary windi ngs of a 600 kVA transformer have resistance of 0.4 Ω and 0.001 Ω respectively. The primary and secondary voltages are 6000 V and 200 V respectively. The iron loss is 32 00 W. Calculate the efficiency on full load at the load power factor being 0.8
  • b
    Why does not use of transformer in DC supply and derive the EMF equation?
  • a
    Explain the working principle of DC generator and also Deriv e the EMF equation of DC generator
  • b
    Calculate the emf generated by a 6 pole DC generator having 480 conductors and driven at a speed of 1200 rpm. The flux per pole is 0.012 Wb. Assume the generator to be (a) Lap wound, (b) Wave wound
  • a
    What is Bus-bars in power system? Write the type of Bus-bars . Explain the single Bus-bars system
  • b
    What is ELCB and why it is used? Explain the Voltage type of ELCB with suitable diagram

Question text is extracted from the official AKTU question paper PDF above. Hindi translations are omitted — every question is printed in English in the original paper. Last verified: 2026-08-23.

Repeated Questions — BEE101

Questions that appeared in more than one session, found by comparing 4 years of Fundamentals Of Electrical Engineering papers (2022-23, 2023-24, 2024-25, 2025-26)

3x

Draw the phasor diagram of pract ical transformer at no load condition

Appeared in: 2022-23 · 2023-24 · 2024-25